SHURE MX393/O MIKROFON

Gyártó: SHURE

Elérhetőség: rendelésre

SHURE MX393/O MIKROFON

SHURE MX393O
Határfelület Mikrofon

  • Gömb Karakterisztika
  • Beépített előerősítő
  • TA3F-XLR Kábel
  • Sízn: fekete

Omnidirectional, BlackAll measurements taken with microphone mounted on a wooden surface 76.2 cm x 76.2 cm (30 in. x 30 in.).

 
Frequency Response
50 to 17,000 Hz
 
Polar Pattern
Cardioid (MX392/C, MX393/C)
Supercardioid (MX392/S, MX393/S)
Omnidirectional (MX392/O, MX393/O)
 
Output Impedance
EIA Rated at 150 ohms (180 ohms actual)
 
 
Sensitivity (at 1 kHz, open circuit voltage)
Cardioid Cartridge: -27.5 dBV/Pa (42.2 mV)
Supercardioid Cartridge: -26.5 dBV/Pa (47.3 mV)
Omnidirectional: -22.0 dBV/Pa (79.4 mV)
1 Pascal=94 dB SPL
 
Maximum Sound Pressure Level (1 kHz at 1% Total Harmonic Distortion, 1 k ohm load)
Cardioid: 117.0 dB
Supercardioid: 116.0 dB
Omnidirectional: 111.5 dB
 
Signal to Noise Ratio (referenced at 94 dB SPL)
Cardioid: 71.0 dB
Supercardioid: 72.0 dB
Omnidirectional: 76.5 dB
 
Equivalent Output Noise (A-weighted)
Cardioid: 23.0 dB SPL
Supercardioid: 22.0 dB SPL
Omnidirectional: 17.5 dB SPL
 
Dynamic Range
94.0 dB
 
Common Mode Rejection
45 dB minimum, 10 Hz to 100 kHz
 
Switch Attenuation
50 dB minimum
 
Preamplifier Output Clipping Level
-6 dBV (0.5 V)
 
Polarity
Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector.
 
Logic Connections (MX392 Only)
LED IN: Active low (<1.0v), TTL compatible. Absolute maximum voltage: -0.7V to 50V.
SWITCH OUT: Active low (<0.5V), sinks up to 20mA, TTL compatible. Absolute maximum voltage: -0.7V to 24V (up to 50V through 3 k ohms).
 
Power Requirements
11 to 52 Vdc phantom
2.0 mA current consumption
 
Environmental Requirements
Operating Temperature Range: -18 to 57 degrees C (0 to 135 degrees F)
Relative Humidity: 0 to 95%
 

Értékelések, vélemények

Ismeri, használja? SHURE MX393/O MIKROFON
Ossza meg véleményét a termékkel kapcsolatban!

Ezek is érdekelhetnek

Kosár
Tovább a kosárba
vásárolok még