SHURE VP88 KONDENZÁTOR SZTEREO MIKROFON

SHURE VP88
Sztereó Kondenzátor Mikrofon

Type

Single-point stereo (MS configuration) condenser

Frequency Response

40 to 20,000 Hz

Polar Pattern

Mid Cartridge: Cardioid (unidirectional)

Side Cartridge: Bidirectional

Output Impedance

Rated at 150 (100 ohms actual). Recommended minimum load impedance: 800 ohms (may be used with loads as low as 150 ohms with reduced clipping level)

Sensitivity (1 kHz, MS mode)

Open Circuit Voltage: -66 dB (0.5 mV) Mid. (Side level 1.6 dB higher than Mid level) (0 dB=1 V/Pa)

Side Level (Stereo mode; relative to Mid level)

Low: -6.0 dB; Medium: -1.9 dB; High: +1.6 dB

Clipping Level (1 kHz)

800 ohm Load (less than 1% THD)

-12 dBV (0.25 V)(Mid output, 1% THD)

-10 dBV (0.30 V)(Side output, 1% THD)

150 ohm Load (less than 3% THD)

-25 dBV (0.06 V)(Mid output)

-19 dBV (0.11 V)(Side output)

Maximum SPL

800 ohm Load: 129 dB

150 ohm Load: 119 dB

Hum Pickup

-4 dB equivalent SPL in 1 millioersted field (60 Hz)

Self Noise (Mid, Side, Left and Right outputs; equivalent sound pressure levels)

24 dB typical, A-weighted

28 dB typical, weighted per DIN 45405

Dynamic Range

105 dB (maximum SPL to A-weighted noise level)

Signal-to-Noise Ratio*

70 dB (IEC 651) at 94 dB SPL

*S/N ratio: difference between microphone output at 94 dB SPL and microphone self-noise A-weighted.

Overvoltage Protection

Maximum External Voltage applied to Pins 2 through 5 with respect to Pin 1: +/- 75 Vdc

Polarity

Positive pressure applied from any direction to the Mid cartridge or from the left to the Side cartridge in the MS mode, or applied from the front in the Stereo mode produces positive voltage on pin 2 relative to pin 3 (Mid/Left) and pin 4 relative to pin 5 (Side/Right).

Power

Phantom

Supply Voltage: 9 to 52 Vdc

Current Drain: 1.3 mA/output; 2.6 mA total

Battery

Type: 6 V cylindrical*

Life: 70 hours**

Current Drain: 2.4 mA total

*Silver oxide (NEDA 1406SOP), lithium (NEDA 5005L), alkaline (NEDA 1414A)

**Fresh silver oxide or lithium battery; 40 hours with alkaline

Environmental Conditions

Operating: -18 to 57 degrees C (0 to 135 degrees F) (Relative Humidity <90%)

Storage: -29 to 74 degrees C (-20 to 165 degrees F) (Relative Humidity <80%)

Cables

Y-Splitter Cable (supplied): 0.76 m (30 in.) vinyl-jacketed, dual? shielded, 2-conductor with 5-pin female XLR connector on microphone end and two 3-pin male XLR connectors on equipment ends.

Microphone Extension Cable (Model C110; optional): 7.6 m (25 ft.) vinyl-jacketed, shielded, 4-conductor with 5-pin male XLR connector on one end and 5-pin female XLR connector on other end.

Case

Brass and nickel-plated aluminum construction with stainless steel grille. Finished in satin black vinyl enamel

Dimensions

See User Guide

Net Weight

417 grams (14.7 oz) less battery and cable